Intermec Antares 2420 - Page 294

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-26
Code 49 (continued)
Or: To set one of the function codes to a character string:
1. Scan one of these bar codes:
Enter Accumulate Mode / Set Function Code 1
*+/$+CK*
*+/$+CK*
Enter Accumulate Mode / Set Function Code 2
*+/$+CL*
*+/$+CL*
Enter Accumulate Mode / Set Function Code 3
*+/$+CM*
*+/$+CM*
2. Scan any character from the “Full ASCII Bar Code Chart” in Appendix B. You can
define two characters each for Function Codes 1 and 3, and four characters for
Function Code 2.
3. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*