Intermec Antares 2420 - Page 371

Co de 39
Nugget
Configuration Command Reference
9-103
9
Or: To set the serial port protocol for one serial port:
1. Scan this bar code:
Enter Accumulate Mode / Set Serial Port Protocol
*+/$+YU*
*+/$+YU*
2. Scan one of these bar codes to set the COM port:
COM1 COM3
*1.* *3.*
*1.* *3.*
COM4
*4.*
*4.*
3. Scan the protocol setting:
Configurable Polling Mode D
*0* *2*
*0* *2*
Master Polling Binary
*8* *12*
*8* *12*
4. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
5. Repeat Steps 1 through 4 to set the serial port protocol for another serial port.