nuggetf
code39
Getting Started
1-13
1
6. If you are using an Intermec-labeled battery pack (Part No. 063278), make sure you
remove the rubber bumper from the inside of the battery door. Otherwise, you will
not be able to close the battery door.
If you are using a Sony-labeled battery pack, make sure the rubber bumper is
installed over the ridge near the wall on the inside of the battery door. The rubber
bumper on the battery door keeps the battery pack in place.
Rubber bumper
Ridge
Wall
Battery door
242XU.148
7. Hook the bottom edge of the battery door into the bottom case above the backup
battery compartment. Push the door down to close it over the battery compartment.
Push the battery door latch down and slide it toward the top end of the terminal to
lock the door in place.
242XU.088
Battery door
latch
To Next Page
Loading...
