Intermec Antares 2420 - Page 49

nuggetf
code39
Getting Started
1-25
1
TCP/IP Network Parameters
Network Parameter Default Value
Network activate Disabled
Host IP address 0.0.0.0
Terminal IP address 0.0.0.0
Network Port 23
RF domain 0
RF security identification (ID) None (not set)
You use the TRAKKER Antares 2400 Menu System to set these parameters. For a
detailed definition of these parameters, see Chapter 4, “Operating the Terminal in a
Network.”
Note:
If the terminal is on a different IP subnetwork from the DCS 300 or host, you
must also configure the default router and subnet mask. For help, see Chapter 4,
“Operating the Terminal in a Network.”
To set the network parameters
1. From the Main Menu, press
:
or
V
to choose the Configuration Menu and then
press

. The Configuration Menu appears.
Note:
If you are not in the TRAKKER Antares 2400 Menu System, press
T3,
or press
T
to access the Main Menu.
CONFIGURATION MENU
Symbologies Menu
Communications Menu
Terminal Menu
 _` Select item
[Enter] Next screen
[F1] Help
[Esc] Exit
242XU.010