TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
nuggetf
code39
1-26
2. Press
V
to choose the Communications Menu and then press
. The
Communications Menu appears.
COMMUNICATIONS MENU
Primary Network
Advanced Network
Radio
Serial Port [COM1]
Serial Port [COM4]
⁄
_` Select item
[Enter] Next screen
[F1] Help
[Esc] Exit
242XU.011
3. Press
to choose the Primary Network command. The Primary Network screen
appears.
UDP Plus Primary Network TCP/IP Primary Network
PRIMARY NETWORK
Activate:
Disabled
Controller IP Addr:
0.0.0.0
Terminal IP Address:
0.0.0.0
OK CANCEL
PRIMARY NETWORK
Activate:
Disabled
Host IP Addr:
0.0.0.0
Terminal IP Address:
0.0.0.0
OK CANCEL
242XU.186
4. In the Activate field, press
W
to toggle the field and display the 2.4 GHz RF option
and activate radio frequency network communications. Press
V
to move to the next
field.
5. In a UDP Plus network, you set the Controller IP Address. In a TCP/IP network, you
set the Host IP Address.
In the Controller IP Address or the Host IP Address field, type in the IP address for
the DCS 300 or host in your network.
The address field consists of four separate numbers. Each number in the field is
separated by a period and can be a number from 0 to 255. Type the address in the
format nnn.nnn.nnn.nnn and then press
V
.
To Next Page
Loading...
