Co de 39
Nugget
Operating the Terminal in a Network
4-7
4
You can install the T2425s, access points, and DCS 300 in your Intermec UDP Plus
network as shown in the next illustration. The T2425s may only communicate with the
access points that are in the same IP subnetwork. All the terminals and access points in
this illustration communicate with the DCS 300 at IP address 192.9.175.7 using UDP
Plus for the RF protocol.
Installing T2425s in Multiple Subnetworks (UDP Plus)
Access point
Access point
Access point
Router
Ethernet
192.9.200.X
subnetwork
192.9.175.X
subnetwork
TRAKKER Antares
2425 terminals
192.9.175.10
192.9.175.11
192.9.175.12
T2425's cannot roam between subnetworks
242XU.091
TRAKKER Antares 2425 terminals
192.9.200.5, 192.9.200.6
192.9.175.7
DCS 300
To Next Page
Loading...
