Intermec Antares 2420 - Page 177

Nugg
Co de 39
Using Custom Applications
5-5
5
TRAKKER Antares Programmable Terminal Specifications
Products:
T2420
T2425
Serial Communications:
RS-232 serial communications via the terminal serial port and optical link adapter,
communications dock, or the serial interface module
(T2420 option only) RJ11 serial communications via the modem
RF Communications:
2.4 GHz (to 2.4835 GHz ) radio
RF Network support:
There are two options:
• host connectivity through an access point and DCS 300 using UDP Plus
• host connectivity through an access point using TCP/IP
Flash Drive C:
Approximately 750K for user, up to 32 files
Flash Drive D or font set
(option)
Approximately 2MB (of the total 4MB) for use as an extended drive (up to 32 files) or
as storage for a double-byte font set
RAM Drive E:
256K reserved for user application (configurable) , up to 32 files
Extended Drive G:
(T2420 option only) 2MB or 4MB extended drive, up to 32 files
Application:
Programmed in Microsoft C, customer defined, stored on drive C. Maximum size of a
single application is 512K (less the size of the RAM drive, if configured)
Application name:
Customer defined, eight characters with three-character extension
Storing applications:
Multiple (maximum depends on the drive space)
Developing applications:
Using TRAKKER Antares Programmer’s Software Kit or EZBuilder
Downloading applications:
Via RS-232 serial communications from the PC or host computer
Via modem from the PC or host computer
Via RF to the T2425’s flash drive from the DCS 300
Via RF and TFTP to the terminal’s flash drive from a host application