TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
nuggetf
code39
xxii
Conventions for Software Screens and Messages
This manual includes illustrations that represent how the terminals display software
screens and messages. Here are two examples:
MAIN MENU
Configuration Menu
Diagnostics Menu
System Menu
About TRAKKER 2400
_` Select item
[Enter] Next screen
[F1] Help
[Esc] Exit
242XU.007
File Name:
TNAPP F
Conventions for Commands
This manual includes sample commands that are shown exactly as you should type them
on your terminal or network device. The manual also describes the syntax for many
commands, defining each parameter in the command. This example illustrates the format
conventions used for commands:
To send a configuration command from the DCS 300, use this syntax:
$+
command
[
command
]...[
command n
]
where:
$+
is the Change Configuration command.
Command
is a configuration command. For example, BV is the command to set the
Beep Volume on the terminal. Enter the command BV0 to turn off the
beep volume.
You can include multiple configuration
command
parameters in the command to
configure the terminal.
To Next Page
Loading...
