Nugg
Co de 39
Reader Command Reference
8-5
8
2. Scan the bar code label(s) for the data you want to enter. You can scan labels from
the “Full ASCII Bar Code Chart” in Appendix B.
For example, scan this label to change the terminal’s configuration and set the
preamble to the characters ABC.
Change Configuration / Set Preamble to ABC
*$+ADABC*
*$+ADABC*
Or, to edit the accumulated data, scan one of these bar code labels:
Backspace Clear Enter
*-+* *--* **
*-+* *- -* **
Note:
You can create one bar code label by combining Steps 1 and 2 above. Most
of the examples in this manual use one bar code label.
3. Scan this bar code label to exit Accumulate mode and enter the data record.
Exit Accumulate Mode
*-/*
*-/*
To Next Page
Loading...
