Intermec Antares 2420 - Page 259

Nugg
Co de 39
Reader Command Reference
8-17
8
drive:
indicates the drive on the terminal where you want to receive and store
the file. You must include the colon (:) after the drive letter.
filename
is the file you want to receive and save on the terminal.
Keypad: Not supported
Scan: 1. Scan this bar code label:
Enter Accumulate Mode / Receive File
*+/.%*
*+/.%*
2. Scan the bar code label for the communications protocol you want to use.
XMODEM XMODEM-1K YMODEM
*X* *K* *Y*
*X* *K* *Y*
3. Scan the bar code label for the terminal COM port you are using to receive the file.
The label also includes the required comma.
COM1 COM4
*1/L* *4/L*
*1,* *4,*
4. Scan the bar code label(s) for the file you want to receive. You can scan labels from
the “Full ASCII Bar Code Chart” in Appendix B. The label must use this format:
drive:filename
5. Scan this bar code label to exit Accumulate mode and receive the file.
Exit Accumulate Mode
*-/*
*-/*
Or: You can create your own bar code labels to receive files by creating a bar code in this
command format:
.%X
n
,
drive:filename
(for XMODEM)
.%K
n
,
drive:filename
(for XMODEM-1K)
.%Y
n
,
drive:filename
(for YMODEM)