Intermec Antares 2420 - Page 303

Co de 39
Nugget
Configuration Command Reference
9-35
9
The override option is a temporary setting that lets you enable all the reader commands
for as long as you need them. When you want to return to the previous configuration, you
disable the override.
Note:
The Enable Override option is the only bar code label you can scan to enable
reader commands if you have disabled all reader commands (DC0). You can also
enable reader commands in the TRAKKER Antares 2400 Menu System.
Default: All reader commands enabled
Scan: To enable all the reader commands or override the current settings, scan one of these bar
codes:
Disable All Reader Commands Enable All Reader Commands
*$+DC0* *$+DC1*
*$+DC0* *$+DC1*
Disable Override Enable Override
*$+DC2* *$+DC3*
*$+DC2* *$+DC3*
Or: To disable or enable specific reader commands, perform these steps:
1. Scan this bar code:
Enter Accumulate Mode / Command Processing
*+/$+DC*
*+/$+DC*
2. Scan the bar code to disable or enable one reader command.
Note:
If there are two bar codes for a reader command, you must scan them in
order, left to right. Accumulate mode commands are separated into two bar codes
so that the command can be accumulated rather than executed as a command.
Abort Program Backlight
*/$* *%.*
*/$* *%.*
Backspace (continued)
*-* *+*
*-* *+*