Intermec Antares 2420 - Page 398

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Nugg
Co de 39
A-10
Default Configuration for Operations
Parameter Default
Append Time Disabled
Automatic Shutoff Disabled
Beep Volume Very Loud
Command Processing All reader commands enabled
Decode Security Moderate
Display Backlight Timeout 10 seconds
Display Contrast 3 (maximum contrast)
Display Font Type 8x8 font (8 pixels wide by 8 pixels high)
Display Row Spacing 0 (one scan line)
Display Video Mode Original
Flash Memory Configuration Configure for double-byte fonts
Keypad Caps Lock Caps lock off
Keypad Clicker Enabled
Keypad Type Hardware default
Postamble No characters (disabled)
Preamble No characters (disabled)
RAM Drive Size No RAM drive
Resume Execution Allowed
Scan Ahead Disabled
Scanner Mode One-Shot mode
Scanner Redundancy Normal
Scanner Selection All compatible scanners (see Note below)
Scanner Timeout Disabled (no timeout)
Scanner Trigger Level triggering
Suspend/Resume Control Enabled
Time and Date 960101120000
Time in Seconds Disabled
Note: The Scanner Selection command is only used when you have a module for cabled
scanners, a long range scan module, or a high density scan module installed.