Intermec Antares 2420 - Page 437

nugget
Using the Default Applications
D-11
D
Example 3
Connect the TD2400 communications dock to a serial port on the T2485. Use a T2420 to
collect data. Use the TD2400 communications dock to upload data from the T2420 to the
T2485. Data is transmitted to the T2485 and out the RF port to the connected network
devices.
Example 4
Use the T248X as a gateway between the CrossBar network and the Ethernet or RF
network. Connect the T248X as a downline device in your CrossBar network. Connect
the T2480/1 with the Ethernet option to your Ethernet network, or connect the T2485/6
to your RF network. While running the
APPTSK.BIN
or
EM9560.BIN
application, you
can send data from the Ethernet or RF network through the T248X to the 9154 or 9161
and vice versa.
Example 5
Connect the COM1 serial port to the COM2 serial port on a T246X or T248X terminal.
Use the terminal to configure itself by typing and entering configuration commands on
the keypad or keyboard.
Example 6
Connect the serial port on the T248X to the serial port on the T246X terminal. Use the
T248X to configure the T246X by typing and entering configuration commands on the
T248X keypad.