Intermec Antares 2420 - Page 44

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
nuggetf
code39
1-20
The values you set for the terminal’s serial port must match the values set for the host’s
(or other device’s) serial port. You use the TRAKKER Antares 2400 Menu System to set
the parameters on the terminal. For a detailed definition of these parameters, see Chapter
9, “Configuration Command Reference.”
To set the serial port parameters
1. From the Main Menu, press : or V to choose the Configuration Menu and then
press  . The Configuration Menu appears.
Note: If you are not in the TRAKKER Antares 2400 Menu System, press
T3, or press T to access the Main Menu.
CONFIGURATION MENU
Symbologies Menu
Communications Menu
Terminal Menu
 _` Select item
[Enter] Next screen
[F1] Help
[Esc] Exit
242XU.010
2. Press V to choose the Communications Menu and then press  . The
Communications Menu appears.
T2425 Communications Menu T2420 Communications Menu
COMMUNICATIONS MENU

Primary Network
Advanced Network
Radio 
Serial Port [COM1]
Serial Port [COM4]


⁄
COMMUNICATIONS MENU

Serial Port [COM1]
Serial Port [COM4] 



⁄




_` Select item
[Enter] Next screen
[F1] Help
[Esc] Exit


_` Select item
[Enter] Next screen
[F1] Help
[Esc] Exit
242XU.070