TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
2-32
2. Find the two connectors in the backup battery compartment. One connector is
attached to the backup battery. The other connector is attached to the terminal.
Firmly push the two battery wire connectors together until they lock. (The connectors
are keyed so they cannot be connected incorrectly.)
242XU.086
Battery wire
connectors
Backup
battery
3. Gently fold and push the backup battery wires into the open area of the backup
battery compartment near the wall.
242XU.089
Folded wires
4. Install a fully charged main battery pack. For help, see “Removing and Installing the
Main Battery Pack” earlier in this chapter.
To Next Page
Loading...
