Table 55: Software Support for SFP+ Passive Direct Attach Copper Cables for EX Series
Switches (continued)
Cable LengthSoftware Support AddedSwitch
3 ft (1 m), 10 ft (3 m), 16 ft (5 m), and 23 ft (7 m)Junos OS Release 12.2EX4550-32T-AFI,
EX4550-32T-AFO,
EX4550-32T-DC-AFI,
EX4550-32T-DC-AFO,
EX4550-32F-AFI,
EX4550-32F-AFO,
EX4550-32F-DC-AFI,
and
EX4550-32F-DC-AFO
switches
3 ft (1 m), 10 ft (3 m), 16 ft (5 m), and 23 ft (7 m)Junos OS Release 12.3R5EX4550-32F-S switches
3 ft (1 m), 10 ft (3 m), and 23 ft (7 m)Junos OS Release 10.0EX8200 8-port SFP+
line cards
(EX8200-8XS)
16 ft (5 m)Junos OS Release 10.3
3 ft (1 m), 10 ft (3 m), and 23 ft (7 m)Junos OS Release 10.3EX8200 40-port SFP+
line cards
(EX8200-40XS)
16 ft (5 m)Junos OS Release 11.1
NOTE: We recommend that you use only SFP+ DAC cables purchased from
Juniper Networks with your Juniper Networks device.
CAUTION: If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical AssistanceCenter
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommend that youcheck the third-partyoptic or cableand potentially
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
The cables are hot-removable and hot-insertable: You can remove and replace them
without powering off the switch or disrupting switch functions. A cable comprises a
low-voltage cable assembly that connects directly into two 10-Gigabit Ethernet ports,
one at each end of the cable. The cables use high-performance integrated duplex serial
data links for bidirectional communication and are designed for data rates of up to
10 Gbps.
Table 56 on page 136 describes the cable specifications.
135Copyright © 2017, Juniper Networks, Inc.
Chapter 8: Transceiver and Cable Specifications
To Next Page
Loading...
Need help?
General
