Related
Documentation
Line Card Model and Version Compatibility in an EX9200 Switch on page 51•
• Pluggable Transceivers Supported on EX9200 Switches on page 103
• Installing a Line Card in an EX9200 Switch on page 242
• Handling and Storing Line Cards in EX9200 Switches on page 237
EX9200-40F Line Card
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet
interfaces on a single assembly. They are field-replaceable units (FRUs) that you can
install in the line card slots on the front of the switch chassis. Line cards are hot-insertable
and hot-removable: You can remove and replace them without powering off the switch
or disrupting switch functions.
This topic describes:
•
Line Card Models on page 67
•
Line Card Components on page 68
Line Card Models
Table 31 on page 67 shows the model number, description of the line card model, and
the Junos OS release in which the line card was first supported.
Table 31: EX9200-40F Line Card
Junos OS Release RequiredDescriptionModel
12.3R2 or laterA line card with 40 1-Gigabit
Ethernet ports, each of which can
house 1-gigabit small form-factor
pluggable (SFP) transceivers
EX9200-40F
See Figure 34 on page 67.
Figure 34: EX9200-40F Line Card
4—1— LEDs for the portsEjector lever
5—2— 1-Gigabit Ethernet portsLine card LED
3—MIC LED
You can use the show version command to see the version of Junos OS for EX Series
switches loaded on the switch.
67Copyright © 2017, Juniper Networks, Inc.
Chapter 5: Line Cards
To Next Page
Loading...
Need help?
General
