Juniper EX9208 - Removing Cable Management Brackets from an EX9208 Switch; Figure 90: Installing the Cable Management Brackets in an EX9208 Switch

Figure 90: Installing the Cable Management Brackets in an EX9208 Switch
ESD
Slot
Screws
g022012
Tab
Related
Documentation
Cable Management Brackets in an EX9208 Switch on page 36•
Removing Cable Management Brackets from an EX9208 Switch
Ensure that you have the following parts and tools available to remove the cable
management brackets from an EX9208 switch chassis:
•
Electrostatic discharge (ESD) grounding strap
•
Phillips (+) screwdriver, number 1 and 2
To remove the cable management brackets:
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the
ESD points on the chassis.
2. Loosen the captive screws on either side of the chassis by using the screw driver.
3. Remove the cable management brackets.
Related
Documentation
• Installing Cable Management Brackets on an EX9208 Switch on page 267
• Cable Management Brackets in an EX9208 Switch on page 36
Copyright © 2017, Juniper Networks, Inc.268
EX9208 Switch Hardware Guide