Juniper EX9208 Hardware Guide

and used in accordance with the instructions, might cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try
and correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio or TV technician for help.
Nonregulatory Environmental Standards
NEBS compliance—These EX Series switches are Network Equipment Building System
(NEBS) compliant:
•
EX2200-24T and EX2200-48T
•
EX3200-24T, EX3200-48T
•
EX3300-24T, EX3300-48T
•
EX4200-24T, EX4200-24F, EX4200-24F-S, EX4200-48T and EX4200-48T-S
•
EX4300-24T, EX4300-24T-S, EX4300-24P, EX4300-24P-S, EX4300-32F,
EX4300-32F-S, EX4300-48T, EX4300-48T-AFI, EX4300-48T-S, EX4300-48P, and
EX4300-48P-S
•
All EX4500 switches with AC power supplies
•
EX4550-32T-AFO, EX4550-32T-AFI, EX4550-32F-AFO, EX4550-32F-AFI, and
EX4550-32F-S
•
EX4600-40F and EX4600-40F-S
•
All EX6200 switches
NOTE: For the EX6200-48P line cards, the intrabuilding ports must use
shielded intrabuilding cabling or wiring that is grounded at both ends.
•
All EX8200 switches
These switches meet the following NEBS compliance standards:
•
SR-3580 NEBS Criteria Levels (Level 4 Compliance)
•
GR-1089-CORE:EMC and Electrical Safety for Network TelecommunicationsEquipment
•
GR-63-CORE: NEBS, Physical Protection
371Copyright © 2017, Juniper Networks, Inc.
Chapter 36: Agency Approvals and Compliance Statements

Juniper EX9208 Specifications

General

Brand	Juniper
Model	EX9208
Category	Switch
Language	English