Juniper EX9208 Hardware Guide

CAUTION: Do not stack MICs on top of one another or on top of any other
component. Place each MIC separately in the antistatic bag or on the
antistatic mat placed on a flat, stable surface.
8. Place the MIC in an antistatic bag or on its own antistatic mat placed on a flat, stable
surface.
9. Install both the MIC slot cover panels if you will not install any MIC in the MIC slots, or
install one cover panel in the empty portion of the MIC slot if you will install only one
EX9200-10XS-MIC or EX9200-20F-MIC. Do this to protect the interior of the line card
and the switch chassis from dust or other foreign substances and to ensure that the
airflow inside the line card and the switch chassis is not disrupted.
Figure 83: Removing an EX9200-10XS-MIC or EX9200-20F-MIC
253Copyright © 2017, Juniper Networks, Inc.
Chapter 21: Replacing a MIC in an EX9200-MPC Line Card

Juniper EX9208 Specifications

General

Brand	Juniper
Model	EX9208
Category	Switch
Language	English