Juniper EX9208 Hardware Guide

WARNING: Do not remove any MIC from the EX9200-40F line card,
EX9200-40F-M line card, EX9200-40T line card, or EX9200-4QS line card.
Before you begin removing a MIC from an EX9200-MPC line card:
•
Ensure that you have taken the necessaryprecautions to prevent electrostatic discharge
(ESD) damage (see “Prevention of Electrostatic Discharge Damage” on page 351).
•
Ensure that you know how to handle and store the line card (see “Handling and Storing
Line Cards in EX9200 Switches” on page 237).
Ensure that you have the following parts and tools available:
•
(If you will replace the MIC by installing only one EX9200-10XS-MIC or
EX9200-20F-M-MIC) A septum if it is not installedin the line card and screws to secure
the septum
•
One or two MIC slot cover panels and screws for installing the MIC slot cover panels.
You must install both the MIC slot cover panels if you will not install any MIC, or install
one cover panel in the empty portion of the MIC slot if you will install only one
EX9200-10XS-MIC or EX9200-20F-M-MIC.
•
Rubber safety caps to cover transceivers
•
ESD grounding strap
•
Phillips (+) screwdriver, number 2
To remove a MIC from an EX9200-MPC line card:
1. Place the antistatic bag or antistatic mat on a flat, stable surface.
2. Attach the ESD grounding strap to your bare wrist and connect the strap to the ESD
point on the rear panel of the EX9200 switch.
3. Label the cables connected to the MIC so that you can reconnect them correctly.
4. If there are transceivers installed in the MIC, remove them (see “Removing a Transceiver
from a Switch” on page 257).
5. Take the MIC offline by pressing the power button on the MIC until the OK/FAIL LED
on the MIC is unlit or by issuing the following CLI command:
user@host> request chassis mic fpc-slot slot-number mic-slot slot-number offline
6. If you are removing an EX9200-10XS-MIC or EX9200-20F-MIC, grasp the MIC ejector
lever on the faceplate of the line card that is adjacent to the MIC and pull it outward
until the MIC is fully unseated (see Figure 83 on page 253). If you are removing an
EX9200-40T-MIC, grasp the MIC ejector levers on either side of the faceplate of the
line card and pull them outward simultaneously until the MIC is fully unseated (see
Figure 84 on page 254).
7. Grasp the handles on the MIC faceplate and slide the MIC out of the line card.
Copyright © 2017, Juniper Networks, Inc.252
EX9208 Switch Hardware Guide

Juniper EX9208 Specifications

General

Brand	Juniper
Model	EX9208
Category	Switch
Language	English