Juniper EX9208 - Figure 78: Removing a Line Card from an EX9200 Switch

CAUTION: After removing a line card, wait for at least 30 seconds before
installing a line card or removing another line card.
8. If you are not installing a line card in the emptied line card slot within a short time,
install a cover panel over the slot. Do this to protect the interior of the chassis from
dust or other foreign substances and to ensure that the airflow inside the chassis is
not disrupted.
Figure78 on page 246 shows removing a line card from an EX9204 switch. The procedure
and orientation of the line card are the same for EX9208. The procedure is the same for
EX9214 switch; however, the orientation of the line cards is different—it is installed
vertically into the top and bottom of the chassis.
Figure 78: Removing a Line Card from an EX9200 Switch
0
2
1
0
1
ESD
g022032
Line card
Ejectors
Related
Documentation
• Installing a Line Card in an EX9200 Switch on page 242
• EX9204 Switch Hardware Overview
• EX9208 Switch Hardware Overview on page 3
• EX9214 Switch Hardware Overview
Copyright © 2017, Juniper Networks, Inc.246
EX9208 Switch Hardware Guide