Juniper EX9208 Hardware Guide

Table 8: FRUs in an EX9200 Switch (continued)
TypeFRU
Hot-insertable and hot-removable.Fan tray and air filter
Redundant configuration:
•
Master RE module is hot-pluggable.
•
Backup RE module is hot-insertable and
hot-removable.
Base configuration:
•
You must disable the switch before
removing any RE module. See “Taking the
Host Subsystem Offline in an EX9200
Switch” on page 226.
See EX9204 Switch Configurations, “EX9208
Switch Configurations” on page 7, and
EX9214 Switch Configurations.
Routing Engine module (RE module)
Redundant configuration:
•
Master SF module is hot-pluggable.
•
Backup SF module is hot-insertable and
hot-removable.
Base configuration:
•
You must disable the switch before
removing any SF module. See “Taking the
Host Subsystem Offline in an EX9200
Switch” on page 226.
See EX9204 Switch Configurations, “EX9208
Switch Configurations” on page 7, and
EX9214 Switch Configurations.
Switch Fabric module (SF module)
Hot-insertable and hot-removable. We
recommend that you take the line cards
offline before removing them. See “Removing
a Line Card from an EX9200 Switch” on
page 244.
Line cards
Hot-insertable and hot-removable.SFP, SFP+, QSFP+, and CFP transceivers
See “Pluggable Transceivers Supported on
EX9200 Switches” on page 103 for the Junos OS
release in which the transceivers were introduced.
NOTE: Line cards are not part of the base or redundant configuration. You
must order them separately.
17Copyright © 2017, Juniper Networks, Inc.
Chapter 2: Chassis Components and Descriptions

Juniper EX9208 Specifications

General

Brand	Juniper
Model	EX9208
Category	Switch
Language	English