Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

Table 29: Mapping Bulkstats Output to MIB Flies and CLI Configurations for Policy Schema (continued)
DescriptionCLI ConfigurationMIB Object NameMIB File
Bulkstats Output
Column Name
The total number of octets
transmitted out of the
interface, including framing
characters. This object is a
64-bit version of
ifOutOctets
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
out-octetsifHCOutOctetsRFC2863ifHCOutOctets
The total number of packets
that higher-level protocols
requested be transmitted,
and which were not
addressed to a multicast or
broadcast address at this
sub-layer, including those
that were discarded or not
sent. This object is a 64-bit
version of ifOutUcastPkts
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
out-ucast-pktsifHCOutUcastPktsRFC2863ifHCOutUcastPkts
The number of outbound
packets which were chosen
to be discarded even
though no errors had been
detected to prevent their
being transmitted. One
possible reason for
discarding such a packet
could be to free up buffer
space
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
jjifCounterDiscontinuityTime
out-discardsifOutDiscardsRFC1213ifOutDiscards
Collecting Bulk Statistics ■ 227
Chapter 4: Configuring SNMP

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English