Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X - Page 258

Table 29: Mapping Bulkstats Output to MIB Flies and CLI Configurations for Policy Schema (continued)
DescriptionCLI ConfigurationMIB Object NameMIB File
Bulkstats Output
Column Name
For packet-oriented
interfaces, the number of
outbound packets that
could not be transmitted
because of errors. For
character-oriented or
fixed-length interfaces, the
number of outbound
transmission units that
could not be transmitted
because of errors
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
out-errorsifOutErrorsRFC1213ifOutErrors
Customer correlation:
■
FR = DLCI
■
ATM = VPI, VCI
■
IP = RouterName
■
Everything else = not
used
correlatorjuniAcctngIfCorrelatorjuniAcctngifCorrelato
Octets dropped due to
ingress policy; support
64-bit counters
in-policied-octetsjuniAcctngIfInPolicedOctetsjuniAcctngifInPolicedOctets
Packets dropped due to
ingress policy
in-policied-octetsjuniAcctngIfInPolicedPktsjuniAcctngifInPolicedPkt
Packets dropped due to
invalid source address
in-spoofed-pktsjuniAcctngIfInSpoofedPktsjuniAcctngifInSpoofedPkts
Octets dropped due to
egress policy; support 64-bit
counters
out-policied-octetsjuniAcctngIfOutPolicedOctetsjuniAcctngifOutPolicedOctets
Packets dropped due to
ingress policy
out-policied-pktsjuniAcctngIfOutPolicedPktsjuniAcctngifOutPolicedPkts
Scheduler octets droppedout-sched-octetsjuniIpIfStatsOutSchedDropOctetsjuniAcctngifOutSchedOctets
Scheduler packets droppedout-sched-pktsjuniIpIfStatsOutSchedDropPacketsjuniAcctngifOutSchedPkts
The ifIndex of the lower
interface
lower-interfacejuniAcctngIfLowerInterfacejuniAcctngifLowerInterface
-time-offsetjuniAcctngIfTimeOffsetjuniAcctngifTimeOffse
228 ■ Collecting Bulk Statistics
JUNOSe 11.1.x System Basics Configuration Guide