Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X - Page 259

Table 29: Mapping Bulkstats Output to MIB Flies and CLI Configurations for Policy Schema (continued)
DescriptionCLI ConfigurationMIB Object NameMIB File
Bulkstats Output
Column Name
The number of packets,
delivered by this sub-layer
to a higher (sub-)layer,
which were addressed to a
multicast address at this
sub-layer. For a MAC layer
protocol, this includes both
Group and Functional
addresses. This object is a
64-bit version of
ifInMulticastPkts
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
in-mcast-pktsifHCInMulticastPktsRFC2863ifHCInMulticastPkts
The number of packets,
delivered by this sub-layer
to a higher (sub-)layer,
which were addressed to a
broadcast address at this
sub-layer. This object is a
64-bit version of
ifInBroadcastPkts
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
in-bcast-pktsifHCInBroadcastPktsRFC2863ifHCInBroadcastPkts
Collecting Bulk Statistics ■ 229
Chapter 4: Configuring SNMP