Chapter 5: Changing the System Setup
Linx 4900 Operating Manual 100 MP65492–1
5.3.6 Reversing the Printed Message
The Reverse Message option allows you to change the orientation of the
printed message. The message can either be printed in the normal forward
orientation (as viewed at the CURRENT MESSAGE screen), or it can be
reversed.
When the Reverse Message option is set to On, all messages are reversed
when printed.
To reverse the printed message:
Note that printing must be stopped to change the Reverse Message option.
1. At the CURRENT MESSAGE screen, press the [F4] function key.
The SETUP menu is displayed.
2. Scroll through the menu options until the cursor rests at the Reverse
Message option, as shown below:
Figure 5-9 Setup Menu: Reverse Message Option
3. Press the [enter] key to select the option.
4. At the Reverse Message setting, press the Left [ ] or Right [ ]
arrow key to toggle the setting On or Off:
NOTE: Messages are always displayed on the CURRENT
MESSAGE screen in the normal forward orientation, even
when the Reverse Message setting is On.
5. Press the [enter] key to save the setting.
6. Press the [esc] key to exit.
Use this setting... To print the message like this...
Off Normal and forward:
On In reverse, from left to right:
Print Width
Print Delay
Print Count
Reverse Message
49067
SETUP
: 0
: 16
: 9
: Off
>
49275
49276
4900 Op Manual.book Page 100 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
Need help?
General
