Chapter 3: Day-to-Day Operations
Linx 4900 Operating Manual 32 MP65492–1
3.2.5 To Shutdown the Jet
1. Press the [stop] key:
The printer initiates a jet shutdown procedure, which takes
approximately 3 minutes. During jet shutdown the message “Stopping
Jet : Please Wait” is displayed in the Status Line.
When the printer has finished the jet shutdown procedure, what
happens next depends on whether or not the ‘Auto Power Down’
function is enabled:
• The ‘Auto Power Down’ function is enabled as a default—after
the jet is shut down, the printer automatically goes into power
down mode and switches the power off. See the next section for
further details
• If the ‘Auto Power Down’ function is not enabled, after the jet is
shut down, the message in the Status Line changes to “Jet
Stopped : Press Stop Key to Power Down”
4900 Op Manual.book Page 32 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
Need help?
General
