Appendix A: Installation and Setup
Linx 4900 Operating Manual 156 MP65492–1
A.3 Attaching the Printhead to the
Production Line
The printhead can work from any angle if clamped in place with a Linx
printhead bracket. The printhead bracket ensures secure and vibration-free
operation.
Figure A-2 Attaching the Printhead
The distance between the end of the printhead and the surface to be printed
on should be set to the recommended initial setting to ensure optimum
print quality; any other setting may result in substantial deterioration of
print quality.
Printhead Recommended Distance
Ultima 12 mm
Ultima plus 12 mm
Direction of conveyor
The ideal distance between
the printhead and the product
is 12 mm.
68446
4900 Op Manual.book Page 156 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
