Chapter 7: Diagnostics and Maintenance
Linx 4900 Operating Manual 142 MP65492–1
7.3.1 To Clean the Printer Cabinet
WARNING: HAZARDOUS INKS AND SOLVENTS. SAFETY
GLASSES AND SOLVENT RESISTANT PROTECTIVE
GLOVES MUST BE WORN THROUGHOUT THE
FOLLOWING PROCEDURE. FAILURE TO COMPLY WITH
THIS SAFETY WARNING COULD RESULT IN IRRITATION
AND REVERSIBLE LOCAL DAMAGE TO THE EYES, AND
NON-ALLERGIC CONTACT DERMATITIS.
CAUTION: It is very important that the cleaning solvent matches the
solvent type used in the printer. Use of the wrong cleaning fluid is
likely to result in print failures and printer damage, so read the label
and confirm that the solvent is of the correct type.
CAUTION: Do not use excessive amounts of solvent; do not frequently
use solvent to remove ink from the front panel and LCD screen as this
can lead to deterioration of the membrane surface.
CAUTION: Do not use abrasive cleaning agents. Do not use excessive
pressure when wiping the LCD screen; excessive pressure can cause
damage to the surface of the membrane.
General
To clean the printer cabinet, use a soft lint-free cloth lightly soaked in a
mild detergent.
Ink Spillages
If ink is accidentally spilled onto the exterior of the printer, Linx
recommends the following procedures:
To clean this… Do this…
Cabinet Wipe the cabinet clean using a soft lint-free
cloth lightly soaked in solvent.
Front Panel and LCD Wipe the membrane and panel clean using
a soft lint-free cloth lightly soaked in
solvent. Do not apply excessive pressure to
the LCD screen.
4900 Op Manual.book Page 142 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
