Chapter 7: Diagnostics and Maintenance
Linx 4900 Operating Manual 144 MP65492–1
7.3.3 To Refill with Ink or Solvent
WARNING: HAZARDOUS INKS AND SOLVENTS. SAFETY
GLASSES AND SOLVENT RESISTANT PROTECTIVE
GLOVES MUST BE WORN THROUGHOUT THE
FOLLOWING PROCEDURE. FAILURE TO COMPLY WITH
THIS SAFETY WARNING COULD RESULT IN IRRITATION
AND REVERSIBLE LOCAL DAMAGE TO THE EYES, AND
NON-ALLERGIC CONTACT DERMATITIS.
CAUTION: Use only Linx ink and solvent. Do not add ink or solvent
until prompted by the printer. Never add more than one bottle of ink
or solvent at a timeoverfilling the printer with ink or solvent, or
using incorrect inks and solvents could seriously damage the printer.
NOTES:
1. When the printer displays a “3.03 Ink Low” or “3.04 Solvent
Low” system warning, you should refill the printer with ink or
solvent.
2. Before you refill the printer with ink or solvent, do the following:
• Ensure that you are using the correct refill bottles. Refer to
your Printer Care card for the correct ink and solvent types,
or ask your line supervisor
• Verify that the use-by date on the bottle label has not expired.
We recommend that you do not use out-of-date inks and
solvents because they will not guarantee the high standards of
print quality and reliability that you expect from your Linx
printer
3. If you use pigmented inks, shake the refill bottle thoroughly
before use.
4. Read the instructions on the refill bottle before use.
4900 Op Manual.book Page 144 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
