Chapter 3: Day-to-Day Operations
Linx 4900 Operating Manual 42 MP65492–1
3.6 Working with Passwords
The Linx 4900 printer has a password system that allows you to control the
printer functions available to the printer operator. You can elect to work
with the password system On (password controlled access to certain printer
functions), or you can choose to work with the password system switched
Off at a designated ‘user level’.
‘User levels’ determine which printer functions are available; these levels
are Level A, Level B and Level C.
This section describes how to enter a password and how to switch the
password system on or off.
For information on changing a password, see ‘Changing the Passwords’ in
Chapter 5, ‘Changing the System Setup’.
3.6.1 To Enter the Password
When the password system is switched On, you must enter a password at
the PASSWORD screen to perform certain functions:
Figure 3-16 Password Screen
1. At the PASSWORD screen, type in your password and press the
[enter] key. This must be the valid password for Level B, or Level C.
NOTES:
1. If you enter the password incorrectly, the message “Invalid
Password” is displayed on the Status Line. Re-enter the correct
password and press the [enter] key.
2. Passwords are not case sensitive or keyboard sensitive.
3. Use the password you were given during your initial printer
training.
See Also
Enter Password > _
49300
PASSWORD
4900 Op Manual.book Page 42 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
Need help?
General
