Chapter 5: Changing the System Setup
Linx 4900 Operating Manual 116 MP65492–1
5.6 Changing the Passwords
The Change Password option enables you to change the Level B and
Level C passwords.
For further information on the 4900 password system, including switching
the password system on/off, refer to ‘Working with Passwords’ in Chapter
3, ‘Day-to-Day Operations’.
To change a password:
1. At the CURRENT MESSAGE screen, press the [F4] function key.
The SETUP menu is displayed.
2. Scroll to the menu option Change Password and press the [enter] key.
If the Password option is set to On, the PASSWORD screen is
displayed:
Figure 5-23 Password Screen
3. At the PASSWORD screen, enter the password.
NOTE: The password you enter here determines which passwords
you are able to change. Entering the Level B password allows
you to change the Level B password only; entering the Level
C password allows you to change the passwords for Level B
and Level C.
4. The CHANGE PASSWORD menu is displayed:
Figure 5-24 Change Password Menu
5. To change a password, overtype the existing password by entering
between four and 10 characters.
Note that passwords are not case sensitive.
6. Press the [enter] key to confirm your entry.
7. Press the [esc] key to exit.
Make sure you record the new password in a secure place.
Enter Password > _
48040
PASSWORD
>
Level B
Level C
: ****1
: ****2
49314
CHANGE PASSWORD
Tip
4900 Op Manual.book Page 116 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
Need help?
General
