Chapter 6: Remote Interface Setup
MP65492–1 121 Linx 4900 Operating Manual
6.3.2 Serial Parameters Menu
The SERIAL PARAMETERS menu options define the communications
parameters used by the serial hardware to determine the format and speed
of the transferred data:
Figure 6-3 Serial Parameters Menu
Note that both the transmitter and receiver should use the same serial
parameters for successful transmission and reception to take place.
The SERIAL PARAMETERS menu includes the following options:
• Baud Rate
This option determines the transfer speed of the data and can be set to
9600 or 19200.
• Stop Bits
This option determines the number of Stop Bits used. The value can be
set to 1, 1.5 or 2.
• Parity
This option determines the type of Parity Bit to be used. It can be set to
None, Odd or Even.
• Data Bits
This option shows the number of Data Bits used. This is for display
purposes only and cannot be changed.
>
Baud Rate
Stop Bits
Parity
Data Bits
: 9600
: 1
: None
: 8
49317
SERIAL PARAMETERS
4900 Op Manual.book Page 121 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
