Chapter 3: Day-to-Day Operations
MP65492–1 35 Linx 4900 Operating Manual
3.2.7 Emergency Stop
In an emergency situation you may need to stop the printer quickly. Use
one of the following methods to do this:
• Switch the printer’s wall mounted electrical isolator to the off position
to shut off the electricity supply to the printer
• Switch the printer’s mains power supply switch at the rear of the
printer to the ‘0’ (off) position
Note that if you use either of the above methods of stopping the printer,
you may lose any recent changes made to the printer settings.
CAUTION: Wherever possible, do not leave the printer in this state
for too long as this may result in ink blockages. You should clean the
printhead and restart the jet, then carry out a normal jet shutdown
and power down using the correct procedures as soon as possible.
4900 Op Manual.book Page 35 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
