Appendix D: System Event Messages
MP65492–1 197 Linx 4900 Operating Manual
D.2 System Failures
1.00 Internal Failure
1.01 Stack Overflow
1.02 Corrupt Program Data
1.03 Unexpected Interrupt
1.04 Unexpected RST
1.05 Unexpected NMI
Description: Undefined software failure.
Cause(s): Unknown
Solution: Contact your local Linx distributor.
Description: Memory allocation has been exceeded.
Cause(s): Programming error.
Solution: Power down and restart the printer.
If failure persists, contact your local Linx distributor.
Description: Program and/or data stored in memory is corrupt.
Cause(s): Unknown.
Solution: Contact your local Linx distributor.
Description: Software has been reset after receiving an interrupt
signal.
Cause(s): Undefined software interruption.
Solution: Contact your local Linx distributor.
Description: Software has been reset after receiving a corrupting
signal.
Cause(s): Undefined software interruption.
Solution: Contact your local Linx distributor.
Description: Software has been reset after receiving an interrupt
signal.
Cause(s): Undefined software interruption.
Solution: Contact your local Linx distributor.
4900 Op Manual.book Page 197 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
