Chapter 6: Remote Interface Setup
MP65492–1 125 Linx 4900 Operating Manual
6.3.6 Print Mode Menu
In addition to the static printing process, where data is downloaded for
printing and then printing is started, using the Print Mode menu, the
printer can be set up to receive data while printing:
Figure 6-7 Print Mode Menu
Using the PRINT MODE menu options enable you to control the
following:
• Circumstances under which printing takes place
• Field data download during printing
• Failure conditions
• Issuing of print control characters
• Size and amount of data received
The PRINT MODE menu includes the following options:
• Mode
The Mode option can be set to Continuous or Single print:
This setting... Does this...
Continuous Printing always takes place, regardless of
whether or not any remote data has been
received. Therefore, if one set of remote
data is received, this is printed continuously
until more remote data is received.
Single Printing takes place once for each set of
remote data received. If no more data is
received, any print triggers that occur are
dealt with according to how the failure
condition has been set up (see below).
>
Mode
Print Go / No Data
Print Go / Pixel RAM
Clear Remote Buffers
Number Of Buffers
: Continuous
: Warn/Ignore PG
: Warn/Ignore PG
: On
: 2
49321
PRINT MODE
4900 Op Manual.book Page 125 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
Need help?
General
