Chapter 6: Remote Interface Setup
Linx 4900 Operating Manual 124 MP65492–1
Each of the following characters can be enabled or disabled (On or Off
state) as appropriate, and each character can be set in the range 1 to 31.
• Print Trigger Char
The Print Trigger character can be issued by the host device to start a
print. The printer treats this character in the same way as a product
sensor trigger and starts the print delay. The Primary Trigger option
in the SETUP menu should be set to Remote for the Print Trigger
character to be actioned.
• Print Delay Char
The Print Delay character is issued by the printer when a photocell
trigger occurs, i.e. just before the print delay starts. If the Primary
Trigger option in the SETUP menu is set to Off, this character is not
sent, as, under these circumstances, a photocell trigger never occurs.
• Print Go Char
The Print Go character is issued by the printer at the end of the print
delay, i.e. when printing is about to commence.
• Print End Char
The Print End character is issued by the printer when printing stops,
i.e. when a ‘stop print’ command is issued or the message print count
reaches 0 with no other message pending.
4900 Op Manual.book Page 124 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
Need help?
General
