Appendix D: System Event Messages
Linx 4900 Operating Manual 204 MP65492–1
D.4 System Warnings
3.00 Shutdown Incomplete
3.02 Memory Corrupt
3.03 Ink Low
3.04 Solvent Low
Description: The printer did not complete the shutdown sequence.
Cause(s): Printer was powered down before the shutdown
sequence was completed.
Printer was switched off while the jet was still running.
A Print Failure occurred.
Solution: Clean the printhead. See Chapter 7, ‘Diagnostics and
Maintenance’.
1. Press the [start] key to start the jet
2. Press the [stop] key to stop the jet
3. Power down the printer
4. Power up the printer
Description: Printer memory is corrupt.
Cause(s): Electrical disturbance.
Solution: Contact your local Linx distributor.
Description: The ink in the ink tank has fallen below the minimum
level.
Cause(s): Low level of ink in the ink tank.
Solution: Refill the ink tank with ink. See Chapter 7, ‘Diagnostics
and Maintenance’.
Description: The solvent in the solvent tank has fallen below the
minimum level.
Cause(s): Low level of solvent in the solvent tank.
Solution: Refill the solvent tank with solvent. See Chapter 7,
‘Diagnostics and Maintenance’.
4900 Op Manual.book Page 204 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
Need help?
General
