Chapter 4: Creating and Editing Messages
MP65492–1 65 Linx 4900 Operating Manual
The EDIT MESSAGE screen is displayed:
Figure 4-15 Edit Message Screen
4.6.2 To Edit a Message
Note that printing must be stopped. If necessary, press the [F1] function
key to stop printing.
1. Select the message for editing. Refer to ‘To Select a Message for
Editing’ on page 64 for details.
2. With the selected message displayed in the Message Display Area of
the EDIT MESSAGE screen, edit the message by selecting each field
in turn and making the required changes:
The section in this chapter ‘Working with Message Fields’ on page 60
gives you detailed instructions on how to select and edit all types of
fields.
3. When you have finished, press the [F4] function key to save the
changes and exit.
The CURRENT MESSAGE screen is redisplayed, showing the
edited message.
Press this key... To...
[enter] Select a field for editing.
[shift] + [ ] or [ ],
[], []
Move to the start, end, top or bottom of the
message.
[ ], [ ], [ ] or [ ]
Move the cursor up, down, left or right (by
one character).
[ctrl] +[ ], [ ], [ ] or
[]
Move the cursor up, down, left or right (by
one drop).
[F1] Change the character size.
[F2] Switch the bold factor on/off.
[F3] Change the field type.
[F4] Save changes and exit.
[del] Delete the selected field.
49030
F1 : Size 16 FH (Caps)
F3 : Field Type
F2 : Bold Off
F4 : Save & Exit
EDIT MESSAGE : MESSAGE 1
LINX PRINTING
4900 Op Manual.book Page 65 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
