Appendix A: Installation and Setup
MP65492–1 157 Linx 4900 Operating Manual
A.3.1 Routing the Printhead Conduit
Ensure that the following printhead conduit guidelines are adhered to:
• Don’t force the conduit to take a sharp bend
• Leave a loop in the conduit to take up movements on dynamic
applications (use a 4 m conduit to assist with this type of application)
• Ensure that the conduit has adequate (fixed) support
• Remember to allow adequate access for printhead cleaning
• Ensure that there are cut-outs in machinery guarding to prevent the
conduit being crushed when the guards are closed
• Ensure that the conduit is not in contact with sharp edges
NOTE: Refer to Appendix F, ‘Technical Specification’ for the dimensions
of the conduit length, diameter and minimum bend radius.
4900 Op Manual.book Page 157 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
