Chapter 3: Day-to-Day Operations
MP65492–1 39 Linx 4900 Operating Manual
3.4.2 To Reset the Print Count
The Print Count option displays the total number of prints made by the
printer. You can change this figure to reset the count. To do this:
1. At the CURRENT MESSAGE screen, press the [F4] function key.
NOTE: If the Password system is switched On, the PASSWORD
screen is displayed at this point and you must enter a
password to continue.
The SETUP menu is displayed.
2. Scroll through the menu options until the cursor rests at Print Count,
as follows:
Figure 3-13 Setup Menu: Print Count Option
3. To reset or to change the value, press the [enter] key to select the Print
Count option then overtype the number.
4. Press the [enter] key to confirm your entry.
5. Press the [esc] key to exit.
Solvent The solvent level status:
OK solvent level is acceptable.
LOW solvent level is low.
You should add one bottle of solvent. See
Chapter 7, ‘Diagnostics and Maintenance’ for
instructions.
Ink The ink level status:
OK ink level is acceptable.
LOW ink level is low.
You should add one bottle of ink. See Chapter
7, ‘Diagnostics and Maintenance’ for
instructions.
This parameter... Indicates...
Print Height
Print Width
Print Delay
Print Count
49066
SETUP
: Normal
: 0
: 16
: 9
>
4900 Op Manual.book Page 39 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
