Chapter 2: Getting Started
MP65492–1 21 Linx 4900 Operating Manual
2.7 Shutting Down and Switching
Off
WARNING: DO NOT USE THE MAINS POWER SUPPLY
SWITCH (ROCKER SWITCH AT THE REAR OF THE
PRINTER) TO STOP THE PRINTER, EXCEPT IN AN
EMERGENCY. SHUTDOWN AND POWER OFF SHOULD
ALWAYS BE CARRIED OUT FROM THE PRINTER
CONTROL PANEL.
2.7.1 To Shut Down the Jet
1. Press the [stop] key:
The printer initiates a jet shutdown procedure, which takes
approximately 3 minutes. During jet shutdown the message “Stopping
Jet : Please Wait” is displayed in the Status Line.
When the printer has finished the jet shutdown procedure, the message
changes to “Jet Stopped : Press Stop to Power Down”.
2.7.2 To Power Down and Switch Off
Powering Down and Switching Off Automatically
The ‘Auto Power Down’ function is set, as a default, to initiate
automatically, so that after the jet is shut down, the printer automatically
goes into power down mode (see Figure 2-16) and switches off the printer:
Figure 2-16 Auto Power Down Screen
When the countdown reaches zero, the power to the printer is switched off,
and the printer Display and the Power LED indicator extinguish.
NOTE: that the mains power supply switch (rocker switch) at the rear of
the printer remains in the On position.
49023
AUTO POWER DOWN
About to power down in:
10 seconds
Press any key to resume
4900 Op Manual.book Page 21 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
