Appendix F: Technical Specification
Linx 4900 Operating Manual 220 MP65492–1
F.1.3 Power Requirements
This equipment is a Class 1 earthed appliance as defined by EN60950.
Electrical connections at the rear of the cabinet comply with the extra low
voltage safety requirements as defined by EN60950.
WARNING: THIS PRINTER MUST BE EARTHED/
GROUNDED.
The integrity of the insulation resistance between the live conductors and
earth has been tested in accordance with the test defined in EN60950.
The integrity of the protective earthing conductors has been tested in
accordance with the test defined in EN60950.
F.1.4 Environmental
F.1.5 Ink System
Construction
Capacity
Pressure
Level Control
Voltage: Single phase, 100 V (3 A) to 230 V (1 A)
a.c., 50/60 Hz
Power rating: 200 VA
Operating temperature: +5 °C to +45 °C ambient
Humidity range: Maximum of 90% relative humidity, non-
condensing
Acoustic emission: Less than 70 dBA
Water and dust: Protected to IP55
Ink system enclosure: Stainless steel
Ink tank: Natural polyethylene
Solvent tank: Natural polyethylene
Ink tank: 1440 ml approximately
Solvent tank: 1440 ml approximately
Operating range: Up to 4.49 bar (65 p.s.i.)
Maximum pressure: 6.21 bar (90 p.s.i.) under fault conditions
Ink tank sense low: Warning reported at approximately 740 ml
Solvent tank sense low: Warning reported at approximately 740 ml
4900 Op Manual.book Page 220 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
Need help?
General
