Safety
MP65492–1 (v) Linx 4900 Operating Manual
Operating the Printer
All personnel operating the printer must be aware of the hazards associated
with ink jet printers. The following safety information should be made
available to all personnel and is applicable to anybody in the printer’s
operating environment.
Only personnel who have been fully trained and authorized by Linx are
qualified to operate or maintain Linx printers. If you are in any doubt as to
your abilities to operate or maintain the printer, DO NOT DO SO; consult
your supervisor for guidance or contact your local Linx distributor who
will be happy to advise you.
• DO NOT smoke or use naked flames in the vicinity of the printer. The
printer contains flammable inks and solvents
• ALWAYS ensure that the printer electrical supply is isolated prior to
performing cleaning or maintenance activities. Lethal voltages are
present in the printer cabinet and printhead when mains power is
applied, which can cause death or serious injury if the correct
electrical procedures are not observed. When an external alarm is
connected to the printer alarm output, this must be disconnected
before any maintenance activities are carried out.
Never attempt to remove the printer cover. The printer cover
must only be removed by fully trained, Linx approved service
engineers
• ALWAYS check that all covers are correctly fitted to the printer before
you use it. If you are not sure, ask your supervisor for guidance.
Covers act as safety barriers and also ensure the printer retains its
electromagnetic compatibility
• It is recommended that the printer is situated at least 600 mm from
floor level for your comfort
4900 Op Manual.book Page v Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
Need help?
General
