Chapter 3: Day-to-Day Operations
MP65492–1 29 Linx 4900 Operating Manual
3.2.3 To Start Printing
1. Press the [start] key.
The printer starts up the jet, and the Status Line displays the message
“Starting Jet : Please Wait”.
When startup is complete:
• The message “Starting Jet : Please Wait” disappears from the
status line
• The options on the left side of the screen change to display “F1 :
Stop Print” and “Status : Printing” (see Figure 3-4 below)
• The green Ready LED indicator on the Printer Control Panel
lights
• The printer starts printing
Figure 3-4 Current Message Screen—When Printing
NOTE: Actual printing is controlled by the line settings configured for
your production line. For further information, see ‘Line Settings’
on page 30).
49058
F1 : Stop Print
Status : Printing
F2 : Check Status
F4 : Change Setup
CURRENT MESSAGE : MESSAGE 1
LINX PRINTING
See Also
4900 Op Manual.book Page 29 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
