Chapter 2: Getting Started
MP65492–1 23 Linx 4900 Operating Manual
The power to the printer is switched off, and the printer Display, and
the Power LED indicator extinguish.
Note that the mains power supply switch at the rear of the printer
(rocker switch) remains in the ON position.
WARNING: WHILE THE MAINS POWER SUPPLY SWITCH
IS SET TO THE ON POSITION ( I ) , MAINS VOLTAGES ARE
STILL PRESENT WITHIN THE PRINTER CABINET.
2.7.3 Emergency Stop
In an emergency situation you may need to stop the printer quickly. Use
one of the following methods to do this:
• Switch the printer’s wall mounted electrical isolator to the off position
to shut off the electricity supply to the printer
• Switch the printer mains power supply switch at the rear of the printer
to the ‘0’ (off) position
CAUTION: Wherever possible, do not leave the printer in this state
for too long as this may result in ink blockages. You should restart the
jet and carry out a normal shutdown using the correct procedure as
soon as possible.
4900 Op Manual.book Page 23 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
