Chapter 3: Day-to-Day Operations
Linx 4900 Operating Manual 34 MP65492–1
Initiating Power Down and Switching Off Manually
If the ‘Auto Power Down’ function is not enabled, or you wish to manually
power down the printer:
1. Stop the jet. To do this, press the [stop] key.
2. Check that the printer status on the PRINT STATUS screen is “Jet
Off”. See ‘Viewing the Printer Status’ on page 38.
3. Press the [stop] key:
The following screen is displayed:
Figure 3-8 Power Down Screen
4. Press the [F1] function key to select Yes (alternatively, press the [F2]
function key to select No and return to the CURRENT MESSAGE
screen).
The power to the printer is switched off immediately, and the printer
Display and the Power LED indicator extinguish.
Note that the mains power supply switch at the rear of the printer
(rocker switch) remains in the ON position.
49024
POWER DOWN
Switch off power?
F1 : Yes
F2 : No
4900 Op Manual.book Page 34 Tuesday, September 9, 2003 12:32 PM
To Next Page
Loading...
Need help?
General
