203
disconnect the ones you do not want to change from their power supply.
It is not possible to display the current setting of a siren.
Tamper on/off
Deactivates the tampering contact of all currently connected “external” sirens for one
hour (useful e.g. to change the batteries).
Please note:
If the tampering contact is disabled, the siren does not transmit status updates to
the alarm panel anymore. For that time, you cannot see the current status of the
tampering contact via the menu “Sensors” “List” “Sensor list”.
Attention! If you open the siren without disabling the tampering contact, the
acoustic alarm of the siren will sound – even if the siren is not connected to the
alarm panel! In this case, you should wear ear protection and disconnect the siren
as quick as possible from its power supply.
Confirmation signal on/off (with Arm / Disarm)
With this function active, the siren will sound one signal tone when arming and two
signal tones when disarming the alarm panel.
Please note:
If the tampering contact of the siren is open when arming or disarming the alarm
panel, five short acoustic signals sound even though the confirmation tone is
disabled. This can happen before the alarm panel displays an open tampering
contact, giving you the possibility to react before a tampering alarm is triggered.
Input on/off
With this function active, the external siren(s) sound confirmation signals for the
duration of the defined delay until the system is armed.
Advanced settings (not for XT1)
Click on to change the settings of your siren. After you have selected the settings to
your preference, they are saved and the siren sounds a brief sound.
This menu is only available for the outdoor siren and small indoor siren V2 (sold since
Autumn 2018). Depending on the type of siren, this menu may look different (e.g. the
small indoor siren does not have the options to set LEDs, since this siren is not
equipped with LEDs.
To Next Page
Loading...