236
Enter the installation mode of the keypad (default 0000 + *). The power LED lights up
orange. To activate the dual key function, you need to enter the following commands for
the corresponding functions:
* + 2 activate dual key 1+3 (panic alarm)
* + 3 activate dual key 4+6 (fire alarm)
* + 4 activate dual key 7+9 (medical alarm)
* + 5 Deactivate all dual key functions
Please note:
To use the enabled dual-key functions, it is required to keep the respective
buttons pressed for at least three seconds.
To use dual key functions, only press the two corresponding buttons on the
keypad. Do not press any other buttons.
F1 – F4 keys (5):
In addition to the dual-key functions, the keypad has four additional control keys, which
can be defined in the sensor properties of the keypad.
You can define if you want to use the F keys without entering a PIN code (or using your
tag) first, or you can secure the F keys, thus, a valid PIN code or tag needs to be used
first.
To do so, open the installer mode by entering the installer PIN code of the keypad
(default 0000) and pressing the * key. The power LED lights up orange.
Then press * + status button.
o If the outdoor keypad beeps fast twice, the legitimization is disabled, i.e.
pressing the keys F1-F4 triggers the linked function (without PIN or tag).
o If a long beep is audible, you can operate the F1-F4 keys only by entering
the PIN code or using the learned tag (default).
To exit the installer mode, press the disarm button twice.
Please Note:
In the sensor properties of the outdoor keypad, you can define the action to be performed
when the keys are pressed (1+3, 4+6, 7+9, F1 - F4). You can define rules, e.g. to switch
on a lamp via a wireless power supply device/in-wall relay.
Overview of the settings in the installer mode:
Open the installer mode by entering the installer PIN code of the keypad (default 0000)
and pressing the * key. The power LED lights up orange. The keypad, if not used, remains
in the installer mode for five minutes before it switches to the standby mode.
The following configurations are possible in the installer mode:
Enable dual-key 1+3 (panic alarm)
Enable dual-key 4+6 (fire alarm)
Enable dual-key 7+9 (medical emergency alarm)
Disable all dual-key functions
To Next Page
Loading...